Day Cab build for Team KNK Hardware

jj650

V.I.P. Member
This is going to be a clean, simple day cab build for Mr. Kirby at Team KNK Hardware.
As it rolls into the shop basically stock except full bearings. Someone already cut the sleeper off and added a cab back, but a little body work needed.

PXL_20210207_154847982_2.jpg

PXL_20210207_154847982_3.jpg

PXL_20210207_161947487.jpg

PXL_20210207_162005904.jpg

PXL_20210207_162017734.jpg

PXL_20210207_161957647.jpg
 

jj650

V.I.P. Member
Did a bumper tuck and raise and also removed the license plate brackets. Cut in a rear window. Dechromed most of the stock plastic. Added Exclusive RC 3D printed dual round headlights. An RC4WD 45t crawler motor mated to a 9 tooth pinion power the stock 3 speed.


PXL_20210213_173800951_2.jpg

PXL_20210213_173805392_2.jpg

PXL_20210213_193720397_2.jpg

PXL_20210213_200008606.jpg

PXL_20210213_204920515_2.jpg

PXL_20210213_163637037.jpg
 
Top